JETSURF Care and Maintenance
Care is part of owning every JETSURF, including electric models. Use this page as a practical starting point, then follow the instructions for your board’s model and generation.
Start with the right manual
Check the model and identification number on your board. Instructions for an older JETSURF, a current DFI board and an Electric 2 can differ. If you cannot identify the right manual, send us a photograph of the identification plate.
Petrol manuals · Electric manuals · All manuals
Before each ride
- With the board switched off, inspect the hull, fins, bindings, control handle and visible connections.
- Check for loose or damaged parts and debris around the propulsion intake.
- Complete your manual’s checks for the cooling system, covers, fuel or battery and safety equipment.
- On petrol boards, check the starting battery even if an alternator is fitted. Frequent starts can use more charge than the alternator replaces.
After riding in the sea
Rinse salt and dirt from the exterior, bindings and control handle with fresh water. Cleaning the exterior does not replace the model’s cooling-system rinse. Follow the manual’s draining and drying procedure before storage.
Petrol boards
Connect a fresh-water hose using a Gardena/Hozelock-compatible connector: directly to the Easy Clean Adapter (ECA) on equipped models, or to the A002091 flushing adapter fitted at the cooling inlet on older models without ECA. Follow the procedure in the manual for your exact model: start the engine before turning on the water, then turn off the water before stopping the engine. Never allow the engine to run without cooling water longer than the manual permits. Apply cleaning and preservation products only where specified.
Electric boards
Electric models also need cooling-system care. Follow the manual’s sequence for draining water, removing the battery after each ride and fitting connector covers. Recharge the battery as soon as practical after use, allowing it to cool first as directed. Use only specified care products for electrical connectors.
Electric 2 models also have scheduled bearing lubrication and connector and seal care. Track operating hours and follow the maintenance schedule for your model.
Storage and longer breaks
Let the board dry in a ventilated place before putting it away. Follow the manual’s instructions for open covers and storage conditions. Petrol-board ICU batteries and electric traction batteries have different requirements. For Electric 2, use the charger’s storage mode to prepare the battery to approximately 50% for long-term storage, and follow the specified temperature guidance. For petrol boards, follow the separate fuel, engine and ICU-battery storage instructions.
Parts and workshop support
For visual guidance on setup and routine care, see the official JETSURF tutorial playlist (English, 2023)
Match the model shown to your board and follow your model’s manual for exact procedures and service intervals.
Use the maintenance schedule for your model. For a parts enquiry, send the model, year, serial number, part number or SKU, and a clear photograph. These details help us check compatibility before you order.
Browse spare parts · Browse care products
If you suspect water has entered a petrol engine, do not repeatedly try to start it. Contact the workshop promptly for the recovery procedure for your model. Stop using the board and contact us if you suspect water in the electrical system, an overheating warning persists, or a cable or battery is significantly damaged.
Choosing your next board? Compare petrol and electric JETSURF models